MAINTENANCE MANUAL
AMT 200S
SECTION:1
MM - 200-25
6.2.5
Record the neutral position in a table as the example below
6.2.6
Release the control stick by removing tool P/N 27100 D/E-A-28 F1.
6.2.7
Move the control stick to full left and measure the travel on the two ailerons.
Record the values in the table shown above.
Note:
Make sure that the left stop-screw P/N TH-5x25-RT (ref. IPC fig.
15 item 6), located at the control stick basement is being not the
primary stop. The primary stop must be in the left bellcrank n° 3
6.2.8
Move the control stick to full right, measure the travel on the two ailerons and
record values.
Note:
Also inspect if the right stop-screw located at the control stick
basement is not the primary stop. The primary stop must be in
the right bellcrank n° 3.
6.2.9
Compare the values measured to the specified parameters below
.
Neutral
Up
Down
AILERON (RH)
ß
(+ 1°)
AILERON (LH)
0° ± 1°
15° ± 1°
15° ± 1°
Neutral
Up
Down
AILERON (RH)
0° ± 1°
15° ± 1°
15° ± 1°
Page 1.21
August 10, 2004 - Rev. 8
AILERON (LH)
α
(+ 1°)
Summary of Contents for AMT 200S SUPER XIMANGO S
