MAINTENANCE MANUAL
AMT 200S
SECTION:1
MM - 200-25
Page 1.22
August 10, 2004 - Rev. 8
6.2.10 If the travel limits measured do not agree with the specified parameters,
continue the rigging procedure.
6.2.11 Move the control stick to full left; adjust the up-position of the left aileron by
regulating the up-stop screw P/N TH-5x25-RT (ref. IPC fig. 13 D item 51) on
left wing and measure the travel on the two ailerons. Compare values to the
specified travel parameters and adjust the left up-stop again if the right aileron
down-position is beyond the limits.
Note:
If it is impossible to put the right aileron on the down position within
limits, stop adjusting the left up-stop screw and continue the
procedure in the right wing.
6.2.12 Move the control stick to full right; adjust the up-position of the right aileron by
regulating the up-stop screw P/N TH-5x25-RT (ref. IPC fig. 13 D item 51) on
right wing and measure the travel on the two ailerons.
6.2.13 Compare values to the specified travel parameters and adjust the right up-
stop again if the left aileron down-position is beyond the limits.
Note:
If it is impossible to put the left aileron down-position within the
limits, stop adjusting the right up-stop screw.
6.2.14 If the aileron travel (up and down position are within the limits, the rigging
procedure is complete and satisfactory. Tighten all adjusted bolts, nuts and
lockwashers and apply torque seal.
6.2.15 If the up-position of one aileron is at the maximum travel limit (16°) and the
down-position of the opposite aileron is less than the minimum limit (14°),
disconnect the control rod P/N 27101 (ref. IPC fig. 13 A item 2) in the right and
left landing gear wells and increase the rod length by turning the fork turnbuckle
rod one turn counterclowise on each control rod.
6.2.16 Repeat all the rigging procedure again starting on item 6.2.1
Summary of Contents for AMT 200S SUPER XIMANGO S
