MAINTENANCE MANUAL
AMT 200S
SECTION:1
MM - 200-25
11.6.1.3
The lever must show positive sign of locking in the down position
(backwards).
11.6.1.4
Make sure that each upper articulated strut does not let the landing gears
retract
11.6.1.5
Make sure that all rod lock nuts are tightened and locked.
11.6.2
The warning must sound in the following situations:
11.6.2.1
Landing gear in transit and airbrakes extended or retracted. Landing gear up
and airbrakes extended.
CAUTION:
Inspect the operation of the warning silencing switch with the airbrakes extended and the landing
gear up or in transit.
11.6.2.2
Inspect all safety pins or wires of the rods; (eliminate all or eventual interferences
which permit the lock nuts and threaded parts to unscrew).
11.6.2.3
Inspect the correct attachment of the micro switches.
11.7
Main Landing Gear - Movable Strut Removal
11.7.1
Put the aircraf on jacks, without touching the ground, and use a toil weight
to avoid aircraft forward drop from jacks.
11.7.2
Release the gas pressure from the shock absorbe.
11.7.3
Remove the brake cylinder assembly.
11.7.4
Remove the landing gear lower cover.
11.7.5
Keep the wheel supported by a block.
11.7.6
Release the torque links by removing its screw.
11.7.7
Remove the plate (flange) by releasing the screws.
11.7.8
Proceed the block release and remove the movable landing gear strut.
12. ldentifying the Main Components
The serial number of each main component permits to identify the correspondent Manufacturing
Control Sheet which was used during manufacture of the component.
The serial number can be found in the Final Inspection Report, furnished for each aircraft and in the
identification placard attached to each component.
Page 1.40
August 10, 2004 - Rev. 8
Summary of Contents for AMT 200S SUPER XIMANGO S
