6
Thoroughly check the craft before every flight…
•
Check to see if any wires have come off
•
Check for loose bolts on the assembly
•
Check that the battery’s are secure
•
Check the battery voltage, and if you have more than one battery, check your spares too
•
Check the propellers for marks and nicks
•
Check the propeller nuts or bolts, make sure they are tight
•
Check the engine mounts and the bolts and nuts for tightness
•
Check the Transmitter battery voltage; never fly the craft with a low voltage reading on your transmitter
(check with the manufacturer of your equipment for minimum and maximum voltage readings).
•
Check that the transmitter antenna is not damaged.
•
Check that the craft receiver module is well connected and that the antenna’s are properly positioned.
•
Take a good look over the craft from all sides to make sure that nothing appears unusual or out of place.
•
Check your flight perimeter.
•
Check for power-lines and overhead obstacles.
•
Assess the weather conditions, wind direction and speed. An anemometer (hand held wind speed meter) is a good tool
to have, otherwise use some dry grass or a tissue, throwing in the air to gauge the wind direction.
•
Do not fly in gusty and turbulent conditions.
•
Set your transmitter timer to 80% of the known battery duration.
DISCLAIMER:
Aeronavics disclaims all warranties, whether express or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose. Aeronavics does not assume
any lyability, whether direct or indirect, from the use of the BOT craft. Aeronavics shall not be liable for any direct, indirect, special, incidental, punitive, contingent or consequential damages to
persons or property caused by the BOT craft. In no event shall Aeronavics be liable for personal injury up to and including death.
Summary of Contents for BOT-Series
