10
3
4
1
Move the “gear switch” of your transmitter
into the “gear down” position.
Tighten the M3 x 12mm SS servo horn bolt firmly.
Close the mechanics arms around the servo horn spline
with your fingers, making sure that they are in the fully
collapsed position…apply firm pressure with your fingers.
2
Undo the M3 x 12mm SS servo horn bolt until the
servo can rotate freely without operating the retract
mechanics – removing the legs allows access between
the bearing shafts with a long shank 2.5mm socket
driver..
5
Test the retracts full movement making sure the servo
motor does not “run” at the gear up or gear down
position.
