AeroPilates 55-5102A, Owner'S Manual

The safety and integrity designed into the 

AeroPilates® Pro Reformer 5102

 can only be maintained 

when the 

AeroPilates® Pro Reformer 5102

 is regularly examined for damage and wear. Special 

attention should be given to the following:

STORAGE

MAINTENANCE

17

1. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

2. Worn or damaged components must be replaced immediately or the 

AeroPilates® Pro Reformer 

5102

should be removed from service until repair is made.

3. Verify that the 

CAUTION LABEL(55) 

and 

PINCH POINT CAUTION LABEL(19)

 are in place and 

easy to read. Call Stamina Products immediately at 1-800-375-7520 for a replacement caution label if 

one is missing or damaged.

4. Verify that the 

ROPES(18)

 are properly installed on the 

PULLEY SETS(22).

5. Check the condition of the 

ROPES(18)

 and replace if they are frayed or worn.

6. Check the 

TENSION CORDS(8, 9, 10).

 If any of the 

TENSION CORDS(8, 9, 10)

 are stretched and 

loose, re-tie the knot on the end of the cord. Replace 

TENSION CORDS(8, 9, 10)

 that are frayed or 

worn.

7. Check the 

BUNGEE CORD(52)

 on the 

CARDIO REBOUNDER(50)

 for wear. Replace the 

BUNGEE 

CORD(52)

 if it is frayed or worn.

8. Check the 

PULLEY SETS(22)

 for excessive wear. Replace worn 

PULLEY SETS(22).

9. Check the 

HAND/FOOT STRAPS(20)

 for damage. Replace damaged parts.

10. Check the 

FOAM SLEEVE(6)

 and 

FOAM PADS(16)

 and replace if damaged or worn.

11. Check the 

STOP PLATES(29)

 for looseness or damage and replace any damaged parts.

12. Check the 

PLATFORM CUSHION(13)

 and replace if it is damaged or worn.

13. Check and clean the 

ROLLERS(32)

 and the rolling surfaces on the rails. Clean by wiping with a dry 

cloth.

14. Only Stamina Products supplied components should be used to maintain/repair the 

AeroPilates® 

Pro Reformer 5102.

15. Keep your 

AeroPilates® Pro Reformer 5102

 clean by wiping it off with an absorbent cloth after use.

1. To store the 

AeroPilates® Pro Reformer 5102,

 simply keep it in a clean dry place.

2. The 

FRONT FRAME(1)

 of the 

AeroPilates® Pro Reformer 5102

 has built-in 

WHEELS(27)

 for easy 

moving. To move, be sure at least one of the tension cords is attached to prevent the 

PLATFORM(7) 

from sliding, then lift from the end of the 

REAR FRAME(2)

 and roll.

3. The 

AeroPilates® Pro Reformer 5102

 folds for storage. To fold, be sure no tension cords are 

attached and slide the 

PLATFORM(7)

 to the end of the 

REAR FRAME(2).

 Remove the 

FOOTBAR(5), 

CARDIO REBOUNDER(50),

 and 

FOAM PAD ASSEMBLIES(16),

 then lift the 

AeroPilates® Pro 

Reformer 5102

 onto its side with the 

LOCKING PIN(28)

 side up. With the machine hinging in the 

middle, move the 

FRONT FRAME(1)

 toward the 

REAR FRAME(2)

 until the frame ends meet. Insert 

the 

LOCKING PIN(28)

 into the hole in the 

REAR FRAME(2),

 and the 

AeroPilates® Pro Reformer 

5102

 is ready to store.

!

   CAUTION

Keep hands clear of the hinge when folding and unfolding the unit.