How to start the Electra safely.
The Electra is a remarkably simple aircraft to start,
taxy and to �ly. Landing is also rather easy which is a
good thing.
The Electra can be started using the CTRL+E method
however if you are feeling adventurous or in fact are
not in too much of a hurry to get off the ground then
you can follow the following few steps.
The following steps assume a cold start. If you have
left the aircraft in an almost ready situation or used
the quick start switch then you can safely skip some
of these steps.
This guide is meant for �lightsimulator use only. If
you are a real world Electra pilot chances are you
probably have a better set of instructions than this.
Please note we provide a set of quick switches that
will allow you to be in complete cold dark start mode
( found on the breaker panel to the left of the pilot )
and a quickstart switch found under the radio stack
on the front panel which allows for an almost ready
to go start. ( Step 6 onwards )
Whilst there isn’t a right or wrong way to start a
Electra, it is good practice to start with the brakes
�irst. Then ensure that the battery is on and that you
have power to the gauges.
This is the step where you do all the things that you
would do if this was real. Now we arent saying that
you shouldnt strap yourself in, clean your windows
etc. But to be honest you might be taking immersion
a little too far.
Quick start guide
Quick switches
Step 1.
Step 2.
Summary of Contents for ELECTRA 10A
Page 1: ......
