AEROPRAKT-32 Pilot Operating Handbook
A32-060-POH
36
Fig. 11. Carburetor heating control
To set the carburetor heating to OFF
– PUSH the control knob (3) forward – the shutter is
set to its lower (open) position and ambient cold air comes through the air intake on top of
the engine cowling. To set the carburetor heating to ON
– PULL the control knob back, the
shutter is set to its upper (closed) position and warm air comes through the duct (1) from
the exhaust muffler.
7.7.6 Brake control system
The main wheel brakes (
) are actuated hydraulically using the brake lever (2)
(installed next to the throttle lever 3) controlling the pressure supplied from the master
cylinder (1) to the slave cylinders (5) in the wheels.
The main LG wheels have disk brakes. The cylinders are connected to each other with
copper tubing 6 with outside diameter of 3 mm. The master cylinder (1) is connected with a
hose (8) to the extension tank (7), installed on the firewall in the engine compartment.
When the brake lever is pulled the brake pads squeeze the brake disc creating the braking
moment proportional to the applied force.
A-32 is equipped also with a parking brake, which is actuated with a lever (4) on the
central console. To use the parking brake, set the lever to 'Parking brake ON', then pull
and release the brake lever. The brake pads will remain pressed to the brake disc. To
release the parking brake set its control lever to its initial position ('Parking brake OFF').
