8
SIP Part No.
07211
Disc Ø
6” (152.4mm)
No Load Speed
10000 rpm
Average Air Consumption
5.3 cfm (150 l/min)
Operating Pressure
6.3 bar (90 psi)
Air Inlet
1/4” bsp
Sound Pressure (LpA) *
86.7 dB(A)
Sound Power (LwA) *
97.7 dB(A)
Vibration **
5.3 m/s
2
Guarantee:
This SIP air sander is covered by a 12 month parts and labour warranty covering failure
due to manufacturers defects. This does not cover failure due to misuse or operating
the sander outside the scope of this manual - any claims deemed to be outside the
scope of the warranty may be subject to charges Including, but not limited to parts,
labour and carriage costs.
Failure to lubricate your air tool will shorten its working life and reduce performance.
The warranty does not cover rusting air tools and tools that failed due to the lack of
lubrication.
Note:
Proof of purchase will be required before any warranty can be hon-
oured.
TECHNICAL SPECIFICATIONS
GUARANTEE
* Measured in accordance with ISO 15744; level of uncertainty 3dB(A).
** Measured in accordance with ISO 28927-3; level of uncertainty 0.033 m/s
2.
9
Ensure the air trigger / throttle (6) is not depressed before connecting to the air
supply.
You will require an air pressure of 90psi, and an air flow according to specifica-
tion.
WARNING!
Ensure the air supply is clean and does not exceed 90psi while oper-
ating the sander. Too high an air pressure and unclean air will shorten the prod-
uct life due to excessive wear, and may be dangerous causing damage and/
or personal injury.
Drain the air tank daily; water in the air line will damage the sander.
Recommended hook-up procedure is shown in fig 1.
Line pressure should be increased to compensate for unusually long air hoses
(over 8 metres). The minimum hose diameter should be 3/8” I.D. and fittings
must have the highest flow rate that can be fitted to the tool.
Keep hose away from heat, oil and sharp edges. Check hose for wear, and
make certain that all connections are air tight secure.
This 6” dual action sander is designed with a durable lightweight composite housing. It
has a built in air regulator for precise control. It is the ergonomic choice for sanding
operations.
DESCRIPTION
AIR SUPPLY
OPERATING INSTRUCTIONS
Tool
Compressor
Quick Connector
Quick Connector
Quick Coupler
Quick Coupler
Air Hose
Regulator
Lubricator
Filter
Cut Off Valve
Fig. 1
