6
Dust Extractor A302
(1).
Flip up the buckle handles on both sides of the barrel with both hands, and open the buckle from the
machine head.
(2)
Hold the handle of the top cover and lift the machine head upward
.
5. Filter replacement and installation (Figure 5)
(1)
Take off the machine head and unplug the used filter from the slot in the front of the machine head.
(2)
Load the new filter along the slot and press it firmly into place.
6. Filter cleaning (Figure 6)
(1)
Remove the filter from the machine head and clean it with tap water.
(2)
The cleaned filter should be naturally dried before being installed on the machine for use, and cannot
be baked.
7. Cleaning the elbow connecting (Picture 7)
(1)
Remove the
elbow
connecting from the machine head and clean it with clean water.
(2).
Install the elbow connecting along the slot, and press it into
.
8. Back blow function operation (8)
(1)
When the suction power of the dust extractor drops, press the elbow of the dust extractor to the
position of the blowback button.
(2)
Repeat pressing 3-5 times to allow the airflow to fully blow off the dust on the filter and increase the
suction.
9. Blow function operation (Figure 9)
(1)
Insert the vacuum tube connector into the blowing port.
(2)
Align the elbow in the dust suction pipe at the corner or deep groove to blow out debris.
10. Water addition control (Figure 10)
(1)
Move the nose of the machine away from the fuselage, and pour water into the barrel with another
container.
(2)
Add the liquid level to the water-level position of the water-level scale line, avoid adding more.
11 Governor operation (Figure 11)
(1)
The adjustment knob for adjusting the suction on the upper part of the switch.
(2)
Rotate the knob to the left to decrease, and to the right to increase.
12. Work with electric sander (Figure 12)
(1)
Insert the suction tube of the dust extractor into the suction port of the power tool.
(2)
Insert the power plug into the sync socket on the panel of the dust extractor.
(3) The switch of the dust extractor is turned to the "second" gear to stand by, and the electric appliance
is turned on to drive the dust extractor to work.
13. Work with pneumatic sander (Figure 13)
(1) Insert the suction tube of the dust extractor into the suction port of the pneumatic tool.
(2) The air pipe joint of the pneumatic tool is inserted into the interface on the air valve seat of the dust
extractor, and the other end is connected to the air compressor.
(3) Turn the dust extractor switch to the "second" gear to stand by, and the pneumatic device is turned on
to drive the dust extractor to work.
Garbage
Cleaning:
1. Remove the back cover from the body together with the dust bag.
2. Remove the inserts of the bottom cloth of the dust bag from one side, and clean up the garbage.
3. Put the insert back on the side of the dust bag, then fix the dust bag on the back cover and install it
back to the whole machine.
Sewage cleaning :
