4.1.1.8. Spread the wings all the way.
Pay attention to the nose bottom part of the sail, it has to be located
between the keel tube and nose channel!
Near the kingpost hole find the shackle of the sweep wire. Pull the shackle out the rear end of the keel pocket, and
check that the sweep wire is not wrapped around the keel. Install the pin of the kingpost to the corresponding place
on the keel tube. Attach the shackle of the sweep wire to the hook which is placed on the keel tube. Install the tangs
on the nose of the sail over the bolt and secure the assembly with a nut.
4.1.1.9. Release the sweep wire from the hook on the keel tube to loose a tension of the sail.
4.1.1.10. The further set up procedure is similar the one from a 6-meter long bag (Section 4.2.2, except points
4.2.2.1-4.2.2.4).
4.2.2 Set up procedure from the package 6 meters long
4.2.2.1. With the glider in the bag (6 meters long) lay the glider on the ground.
