AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
4
1.Remove the pins, fuel cell and battery from
tool.
2. Pull down and lock the follower.
3. Unscrew the knob on the handle connection,
the magazine will release.
4. Clean any residue along the driving path in
the nose piece and pin guide.
5. To install the magazine, fi rst engage the
magazine in the slot of the nose piece
6. Screw the knob on the handle connection.
NOTE:
•
Do not release the magazine with fasteners
inside. The follower may pop the pins out
and cause injury.
•
Wear safety goggles, the jammed fastener
may jump out and hurt the user.
I. Adjust the driving depth
Caution !
•
Please READ and UNDERSTAND the
section 1 “General Safety Instructions” for
personal and working environment safety.
•
Never press the pin guide by bare hand or by
any parts of the body.
•
Never point the tools at anybody.
•
Only pull the pin guide to separate the pin
lock
Steps:
1. Remove the pins, fuel cell and battery
attached on the tool.
2. Pull down and lock the follower.
3. Adjust the knob clockwise to increase the
driving depth, or vice versa.
NOTE:
•
Do not over adjust the knurled depth setting
dial, the threaded pin should be visible and
protrude out from the end of the Dial.
J. Cleaning Filter
The fi lter at the back of the tool acts crucially to
suck in air into the chamber. For maintaining the
best performance of the tool users should always
keep it clean.
1. Unscrew four screws on the back cover
2. Take out the back cover and clean the mesh
with brush or air.
3. Put the back cover on the machine and fasten
with four screws.
NOTE:
•
Do not attempt to use water to clean the
mesh. The cover and mesh must be dry
when operating the tool. If wet it may easily
cause malfunction to the tool.
