background image

AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL

8

3 - COPYRIGHT

Copyright:

Aerosmith Fastening Systems

5621 Dividend Road, 

Indianapolis, IN 46241

United States

Passing on and duplication of this document, 

exploitation and disclosure of its contents 

are forbidden unless expressly approved. 

Violations render the offender liable to 

damages. All rights reserved for the event 

of patent, utility model or registered design 

applications.

This operating manual has been drawn 

up with the greatest care. Nevertheless, 

Aerosmith Fastening Systems assume 

no liability for possible errors in this 

operating manual and their consequences. 

Furthermore, no liability is assumed for 

direct or consequential damages resulting 

from the improper use of the tool.

The national safety and occupational safety 

regulations and the safety precautions given 

in this operating manual must be observed 

when using the tool. All product designations 

and brand names are the property of their 

owners and are not explicitly marked as 

such.

Amendments to content reserved.

4 - DISPOSAL

Separate collection. Local 

regulations may provide for 

separate collection of electrical 

products from the household, at 

municipal waste sites or by the 

retailer when you purchase the 

new product.

Separate collection of packag-

ing and failed rechargeable 

battery in accordance with the 

recycling regulations applicable 

in your country.

5621 Dividend 

Road,  

Indianapolis, 

IN 46241

United States

Tel: 800.528.8183 

Web: http://www.aerosmithfastening.com/

Summary of Contents for GT38LI









Reviews: