A few examples:
If you own a 5-position switch or a real starter key, you can set every
position with variable
L:KEY_STARTER=SET
and the Parameters 0,1,2,3
and 4.
0
will be
OFF
,
4
will be
START
.
If you use a Joystick with a limited number of buttons, you may want to use
one button to turn the key left or one to turn it right. In this case, use
L:BUTTON_KEY_STARTER_DOWN
and
L:BUTTON_KEY_STARTER_UP
.
You can use a 2-position toggle switch for the battery master switch with
L:SWITCH_BATTERY=SET
and using the Parameters 0 and 1.
Or you can use just one button to toggle it
ON/OFF
with
L:BUTTON_BATTERY_MASTER
.
It is possible to use a lever for the carburetor heat with
L:LEVER_CARB_HEAT
. Or to use two buttons to push and pull the lever
with
L:BUTTON_CARB_HEAT
and the parameters 0 and 1. Or to use just
one button: Assign the parameter 1 under
Control sent when button
pressed
and parameter 0 in the
Control sent when button is released
field. That will engange the Carb Heat only as long as the button will be
pressed.
Neither the software nor the documentation may
be used for real aviation and training purposes.
01<33
page
DA20-100 ‘Katana’ 4X Manual
INTRODUCTION AND DESCRIPTION
Summary of Contents for DA20-100
Page 1: ...MANUAL DA20 100 Katana ...
Page 2: ......
