4/28/2021
Nano Shutter User Guide : Aeotec Help Desk
https://aeotec.freshdesk.com/support/solutions/articles/6000198854-nano-shutter-user-guide-
13/15
Instant updates.
By default Nano Shutter is not set to report its status automatically. If you need to have your Nano Shutter report to your
gateway any time its status has been changed, you can do so using the configuration settings below:
Parameter #
Definition
Default Value
Byte Size
80 (0x50)
To set which report would be sent to the associated
nodes in association group 1 when the state of output
load is changed.
0 = Nothing
1 = Basic Report CC
2 = Switch Multilevel Report
2
1
Touch panel control.
As you can see that the Nano Shutter’s surface has a pin port, this port is used to connect the Touch panel. When you
have already connected it to the Nano Shutter, you will be possible to control the Nano Shutter through the Touch panel
directly.
