ABL1500WB-B Hardware Manual
Maintenance
Chapter 4: Maintenance
The ABL1500WB-B series stages are designed to require minimum maintenance. Due to the non-contact air
bearing design, there are no friction surfaces or dynamic seals to wear or require lubrication. However, it is
important to clean the bearing surfaces and encoder strips to maintain the accuracy of the stage. The
bellows require periodic lubrication to maintain smooth motion. This chapter will detail the cleaning and
lubrication process and specify recommended cleaning solvents.
N O T E :
The bearing area must be kept free of foreign matter and moisture; otherwise, the performance
and life expectancy of the stage will be reduced.
D A N G E R : To minimize the possibility of bodily injury or death, disconnect all electrical
power prior to performing any maintenance or making adjustments to the equipment.
4.1. Service and Inspection Schedule
Inspect the ABL1500WB-B at least once per month. A longer or shorter inspection interval may be required
depending on the specific application, and conditions such as the duty cycle, speed, and environment.
Monthly inspections should include but not be limited to:
l
Visually inspect the stage and cables.
l
Re-tighten loose connectors.
l
Replace or repair damaged cables.
l
Clean the ABL1500WB-B and any components and cables as needed.
l
Repair any damage before operating the ABL1500WB-B.
l
Inspect and perform an operational check on all safeguards and protective devices.
4.2. Cleaning and Lubrication
You must periodically re-lubricate the bellows. Lubricating the bellows tracks will promote smooth motion.
Clean all air-bearing surfaces and encoder scales to prevent damage to the stage or decreased performance.
Prevent dust build-up from accumulating in the linear motors, encoders, and air-bearing surfaces by blowing
clean, dry, compressed air over the entire stage. Due to the non-contact design, these surfaces operate very
close together, allowing dust to buildup and cause damage.
All encoder surfaces and magnet tracks should be cleaned with isopropyl alcohol. Aluminum hard-coated
metal surface may be cleaned with isopropyl alcohol or acetone. Acetone should not be used on magnet
tracks because it could break down the epoxy that holds the magnets in place.
Table 4-1:
Recommended Cleaning Solvents
Item
Recommended Cleaner
Encoders, Magnets
Isopropyl Alcohol
Hard-Coated Aluminum
Acetone
Granite
Surface plate cleaner
(1)
1. Surface plate cleaner is available from precision granite manufacturers.
www.aerotech.com
Chapter 4
41
