Laser Shutter
A laser attenuator (beam shutter) is a mechanical or electrical device that blocks the emission of laser
radiation. It is a requirement for most classes of laser systems. The attenuator must be available for use
at all times when the laser system is operated. Power switches and key controls do not satisfy the
attenuator requirement.
The AGV3D scan head does not include a laser attenuator, and therefore it cannot block or weaken the
laser beam. Due to the unique properties of each laser, it is the responsibility of the user to incorporate
an appropriate shutter as per any and all applicable regulations in order to prevent unwanted emission
of the laser beam.
Place the beam shutter between the laser source and the scan head (refer to
).
DANGER
: The danger to your eyes increases when optical instruments are used in
conjunction with the scan head.
l
Wear certified laser safety eye protection.
l
Do not stare into the laser beam, put your body parts in the laser area, or expose
yourself to reflections from powerful beams.
WARNING
: Aerotech recommends that you only use a Class 1 HeNe laser to do
alignments. If a Class 1 HeNe laser is not available, use the lowest power setting on the
available laser and remote beam sensing techniques.
AGV3D Hardware Manual
Laser Shutter
www.aerotech.com
11
Summary of Contents for AGV3D Series
Page 1: ...Revision 2 00 AGV3D Three Axis Laser Scan Head HARDWARE MANUAL...
Page 6: ...This page intentionally left blank List of Tables AGV3D Hardware Manual 6 www aerotech com...
Page 12: ...This page intentionally left blank Laser Shutter AGV3D Hardware Manual 12 www aerotech com...
Page 16: ...Figure 1 2 Standard AGV3D Chapter 1 Overview AGV3D Hardware Manual 16 www aerotech com...
