1.4. AC Power Setting
You can change the BIOS setting on the PC so that, in the event of a power failure, you will not need to
access the PC to manually turn the PC back on. Use this item to select AC power state when power is re-
applied after a power failure.
Table 1-4:
BIOS Settings
PC Type
BIOS Category
Settings
-CC04
-CC05
State after G3
Power On
-R103
Restore AC Power Loss
S0 State
-R402
Restore AC Power Loss
S0 State
-DT01
Restore AC Power Loss
S0 State
1.5. DVI Monitor Configuration (-R103, -R402, -DT01 PC Options)
To let the Windows OS operate without a monitor connected, both the AIMB-785 motherboard and the
standard Advantech-provided BIOS are configured to report to the Windows OS that a VGA monitor is
always connected as the default primary display. If you connect a single DVI monitor to one of the rack
mount (-R103 or -R402) or desktop (-DT01) computers, the BIOS will continue to report to Windows that
the VGA monitor is also connected. You will need to update the Windows Display settings to get the
system to correctly identify the DVI monitor. Either duplicate the Windows desktop to both monitors or
identify and set the DVI monitor as the primary display.
1.6. Environmental Specifications
Table 1-5:
Environmental Specifications
Ambient
Temperature
Operating: 0° to 40°C
Storage: -30° to 85°C
Humidity
Non-condensing
The maximum relative humidity is 80% for temperatures that are less
than 31°C and decreases linearly to 50% relative humidity at 40°C.
Operating Altitude
0 m to 2,000 m above sea level.
If you must operate this product above 2,000 m or below sea level,
contact Aerotech, Inc.
Pollution
Pollution Degree 2
Typically only nonconductive pollution occurs.
Operation
Use only indoors
1.4. AC Power Setting
Automation1 iPC Hardware Manual
18
www.aerotech.com
