Electrical Specifications and Installation
PRO560LM Hardware Manual
3.3. Motor and Feedback Specifications
Table 3-11:
Feedback Specifications
Hall-Effect Sensors Specifications
Supply Voltage
5 V ±5%
Supply Current
50 mA
Output Type
Open Collector
Output Voltage
24 V max (pull up)
Output Current
5 mA (sinking)
Thermistor Specifications
Polarity
Logic "0" (no fault)
Logic "1" (over-temperature fault)
Cold Resistance
∼
100 Ω
Hot Resistance
∼
10 K
Note:
1K pull-up to +5V recommended.
Encoder Specifications
Supply Voltage
5 V ±5%
Supply Current
250 mA Typical
Output Signals
Sinusoidal Type (Incremental Encoder)
: 1 V
pk-pk
into 120 Ω Load (differential
signals SIN+, SIN-, COS+, COS- are .5 V
pk-pk
relative to ground.)
Digital Output (Incremental Encoder)
: RS422/485 compatible
Serial Output (Absolute Encoder):
EnDat 2.2 with 36 bit word
Limit Switch Specifications
Supply Voltage
5 V ±5%
Supply Current
25 mA
Output Type
Open Collector
Output Voltage
5 V
Output Current
10 mA (sinking)
Output Polarity
Normally Closed (NC)
l
Sinks current to ground (Logic "0") when not in limit
l
High impedance (Logic "1") when in limit
l
Requires external pull-up to +5 V (10 kΩ recommended)
Notes:
l
If the PRO560LM is driven beyond the electrical limit, it will encounter a mechanical stop. Impacting the mechanical stop could
cause damage to the stage even at low speeds.
l
Hall effect, encoder, and limit switch 5 VDC supplies are connected by the wiring system of the stage.
36
Chapter 3
www.aerotech.com
