Cap.6 _ Using the compressor
pag.
34
Use and maintenance manual
MCH-36
Check that the level of lubricating oil (
a
) is within
acceptable limits (i.e. between min. and max.).
Note that an excessive quantity of oil can cause
infiltrations in the cylinders and leave deposits on
the valves while too low a level prevents proper
lubrication and could cause engine seizure.
If the oil level is not within the minimum and
maximum limits top up or drain as described in
section “7.6.3 Changing the lubricating oil and filter”.
The use and maintenance manual is an integral part of the compressor and must always be
handed over in the event of a change of ownership.
WARNING:
6.2.1 - LUBRICATING OIL LEVEL CHECK
Inspect the refill hoses and make sure there are no cuts, holes, abrasions, leaks etc. If necessary replace with
new hoses.
6.2.2 - CHECKING THAT THE REFILL HOSES ARE IN GOOD CONDITION
The use and maintenance manual and its appendices must be stored carefully and must always be kept
where they can be accessed easily for immediate consultation.
6.2.3 - STORING TECHNICAL DOCUMENTATION
a
a
6.2 - CHECKS TO BE RUN AT THE START OF EACH WORKING DAY
Inspect the exterior of the compressor (couplings, pipes, pneumatic components etc.) and check for any oil
leaks.
Version produced up to 31-12-2005
Version 2006
