28
2. Gather the following items for the rudder servo
installation:
•
Rudder Servo
•
2 1/2” Servo Arm (Double Servo Arm)
•
Servo mounting screws
•
Aeroworks Safety Clips
4. The cables should allow the tail wheel to move
freely in either direction.
Note:
Check steering cables are securely mounted to
tail wheel steering arm.
5. Install the rudder servo, the output shaft should
face the front of the fuse as shown.
3. The Pull Pull Cables for the tail wheel steering
have been installed at the factory and taped to
the servo floor as shown below. Remove the
tape and test the cables to make sure they are
securely attached at the tail wheel steering tiller
arm.