69
14. With alignment mark aligned and template fit
flush to rear of cowl tape template to bottom of
cowling as shown below.
.
15. Mark cut lines with removable marker.
Note:
Take care and test painted areas prior to
using any type of paint remover, rubbing
alcohols or cleaners to remove any pen lines.
16. Remove the template and use a rotary cutting
tool and sanding drum to cut out the opening in
the cowl.
17. Reinstall the cowl to check the fit of the cylinder
head and muffler.
Note:
Be sure that the cylinder head and muffler
will not rub against the cowl. Make
adjustments as necessary.
Note:
We have found this to be adequate cooling for
the DA 50. Depending on your engine’s oper-
ating temperature, you may need to allow for
more exit air for your engine to run at its rec-
ommended operating temperature.
Always check the operating temperature of
your engine to prevent any damage from
occurring. Aeroworks is not responsible for
damages incurred from improper engine
cooling.
