9
2. Open your kit slowly and take care not to dam-
age any parts of the kit. Remove all parts from
their plastic protective covers for inspection.
Before doing any assembly or installation of any
decals it is very important to re-shrink or re-
tighten the already applied covering. Due to the
shipping process, heat and humidity changes
from different climates, the covering may be-
come lose and wrinkle in the sun. If you take the
time to re-tighten the covering, you will be re-
warded with a long lasting beautifully covered
model.
TIGHTENING AND RE-SHRINKING THE COVERING
3. Using your covering iron with a soft sock, gently
apply pressure and rub in the covering. If any
bubbles occur, your iron may be to hot. Reduce
heat and work slowly.
4. If bubbles persist, use a small pin to punch holes
in the bubble to relieve trapped air and reheat.
1. Remove the rear canopy before applying heat to
the covering. Excessive heat from covering irons
or heat guns can cause the canopy to melt or
warp. Take care not to apply excessive heat to
front section of canopy
