16
Aeroworks 60cc Freestyle Extra 260 Assembly Manual
13. Apply 5 minute epoxy into the control horn
mounting slots and the base plate mounting loca-
tion as shown.
14. Place elevator control horn into the pre-cut slot.
Wipe away any excess epoxy that may have
come out at this time. Ensure that the base plate
is flat and making full contact with the elevator
at this time.
15. With elevator centered in neutral position, en-
sure the mounting hole of the control horn is
centered on the hinge line as shown. Double
check this alignment while the epoxy cures, it is
very important that the control horn is correctly
aligned with the hinge line.
16. Install servo with the output arm toward the
leading edge of the stab. Drill holes for servo
mounting screws
11. Use a hobby knife to carefully remove the cover-
ing. Take care not to cut to deep and damage the
wood underneath the covering
12. Final picture of removed covering shown below