Aeroworks 60cc Freestyle Extra 260 Assembly Manual
19
1. Gather the items shown below for the installa-
tion of the rudder servo and pull-pull cables.
Required Parts - Included
2 - Double Truss Fiberglass Control
Horns- Dual output
2 - Control Horn Base Plates
2 - Pull-Pull Cables
4 - Brass Swag Tubes
4 - 4-40 Ball Link Couplers
4 - 4-40 Ball link Assemblies
4 - 4-40 x 20mm Bolts
4 - 4-40 Flat Washers
4 - 4-40 Lock Nuts
Required Parts-Not Included
1 - Rudder Servo w/ mounting hardware
1 - 3” Double Output servo arm
Required Tools and Adhesives
1/16” Ball Driver
Small Phillips screw Driver
Wire Cutters
Pliers
1oz Bottle Thick CA Glue
Masking Tape
RUDDER SERVO/PULL-PULL
INSTALLATION
7. Ensure there is no gap between fin and rudder.
Check that you have full rudder deflection be-
fore epoxy fully cures. Allow epoxy to fully
cure.
2. Install control horn base plate and 4-40 ball link
between upper and lower dual output control
horns as shown. Remaining 4-40 ball link and
base plate will be installed in a later step.
3. Slide upper and lower rudder horns through the
pre-cut slot in the rudder as shown below.