Aeroworks 60cc Freestyle Extra 260 Assembly Manual
47
8. Route the vent line on top of the fuel tank and
secure with small nylon ties as shown. This will
stop excess fuel from draining out the vent line
during an extended down line or when lifting the
tail.
9. Gather the fuel vent exit dot and hobby knife as
shown below.
Note:
Vent dot available from Aeroworks.
10. Use a hole template to mark a 3/8” hole in the
desired location of the fuel vent exit dot.
11. Use a hobby knife to cut a hole in the bottom of
the fuse forward of the landing gear plate to al-
low the fuel vent exit dot to pass through
12. Route the vent line through the hole made in the
previous step and attach to the fuel vent exit dot.
Use safety wire to secure fuel tubing to fuel vent
exit dot
13. Use thick CA to secure fuel vent exit dot in fuse.
