Aeroworks 60cc Freestyle Extra 260 Assembly Manual
55
14. Finished cowl installation shown below.
Note:
Aeroworks has found this method to provide
sufficient cooling for the engine. It is still
important to check motor temperatures to ensure
it is not running too hot. If your engine does run
hotter than the manufacturer suggests, additional
cooling holes may need to be made in the
cowling.
12. Locate the supplied front air inlet template and
tape to cowl. The front air inlets should be cen-
tered both vertically and horizontally on the en-
gine head. This will allow cool air to pass
through the cowl and into the fins of the engine.
Transfer the template cutout pattern to the cowl
and mark cut location.
13. Locate the supplied bottom air exit template and
tape to cowl. This will allow hot air to pass out
the bottom of the cowling. Transfer the template
cutout pattern to the cowl and mark cut location.