8
Aeroworks 60cc Freestyle Extra 260 Assembly Manual
1. Go over all seams and glue joints with thin CA,
this will ensure your model lasts for many sea-
sons to come.
Note:
Even if you can visibly see glue on all glue
joints it is still recommended that the joints be
re-glued. Due to changes in humidity during
the life of the aircraft glue joints can separate,
it is always recommended that the glue joints
be checked before each flying session.
2. Use thin CA on the canopy mounting tabs and
front dowels as shown.
DO NOT
install canopy
on the fuse until glue has fully cured. Failure to
do so may cause canopy to be permanently glued
to the fuse.
HINGING AILERONS
CHECKING GLUE JOINTS
1. Gather the items shown below for the installa-
tion of the Aileron.
Required Parts - Included
1 - Wing Panel
1- Aileron
7 - Pin Point Hinges
Required Tools and Adhesives
30 Minute Epoxy
Epoxy Mixing Cups/Sticks
Petroleum Jelly
Isopropyl Alcohol
Paper Towels
Builders Tip:
Wet paper towels with isopropyl alcohol before
starting aileron installation. This will make cleaning
any excess epoxy easier once the aileron is in-
stalled.