19
Aileron Servo Installation
1. The ailerons have been pre-hinged and
glued
to
the wing panels and are ready for flight. No
other steps are necessary for hinging. Clear
Covering is supplied for sealing the hinge gaps if
desired. However, due to the precisely aligned
and minimal hinge gap this step is optional.
◊
1 - Wing panel
◊
1 - Aileron servo
◊
1 - 1 1/4” Servo Arm
◊
4 - Servo Mounting Screws (Micro Fastener
Part number
STW0209
recommended)
◊
1 - 12” servo extension
◊
1 - Aeroworks Safety Clip
WING ASSEMBLY
2. Attach the 12” servo extension to the servo wire
and secure using an Aeroworks Safety Clip.
Minimum recommended servo:
181 in. oz. / Metal Geared / Digital
3. Remove the balsa stick with the pull string from
the servo well and tie the pull string to the servo
lead as shown.
4. Pull the servo lead through the root end of the
wing.