21
4.
Align the control horns over the factory
drilled
holes.
Note:
Control horns have been set at a slight
offset to allow for maximum torque at full
deflection
5. Use thick CA on each screw prior to
installing to lock screws in place
Note:
CA glues have a fast drying time.
Remember to work quickly
6.
Plug the servo into the receiver and turn on.
Ensure servo is centered and the servo arm is
parallel to the aileron hinge line. Adjust the
length of the pushrod so that the aileron is at
the neutral position when the servo arm is par-
allel to the aileron hinge line. Ensure the
servo does not fight at center or either end
point at full deflection. Take advantage of
servo programmers and match boxes available
today to achieve best results. This will help
keep servos from binding and causing possible
aileron flutter.
7. Repeat previous steps for the remaining wings.