44
11. Attach the throttle pushrod with the 4/40 ball
links and secure. Power up the receiver and
throttle servo and adjust pushrod for proper op-
eration. Ensure the servo or rod does not bind or
jam at closed or full open positions.
12. If using standard mufflers place motor box cover
back in place and mark the location of the throt-
tle pushrod.
Note:
For improved cooling it is recommended
that the pipe tunnel be left open and the
exhaust holes be opened. This will allow for
extra venting while still maintaining the
cowl structure.
13. Use a drop of thick CA on the throttle servo
mounting screws after they have paced through
the motor box floor as shown below.
14. A none soldering method of attaching throttle
pushrod is shown in the following steps.
Hardware for this method is
not supplied
.
Gather (2) 4-40 ball links, (1) brass spacer,
4-40 all thread, and carbon tube.
