53
IGNITION INSTALLATION
1. Gather the supplied mounting hardware to be
used. Included in the kit are large and small ny-
lon ties, One Wrap Velcro ties, and foam rubber
pads as shown.
2. Gather the ignition accessories as shown below:
◊
1 - Ignition Unit
◊
1 - 2600mah Fromeco Ignition Battery
◊
1 - Smart-Fly Ignition Regulator
◊
1 - MPI Charge Switch
◊
1 - Rcexl Ignition Cutoff
◊
1 - Foam padding
◊
2 - Nylon Ties
3. Position the ignition module inside the engine
box to allow both of the spark plug leads to exit
and properly connect to the engine without ex-
cess tension or chafing. Mark the location for the
nylon tie mounting holes.
4. Use a 1/4” drill bit to drill the nylon tie mount-
ing holes as shown.