COMPACT JUMP STARTER
Premium Protection Cable Operation
Operation
AMBER
solid
COMPACT JUMP STARTER
voltage is lower than 11V (3
bars or less on
COMPACT
JUMP STARTER
). No current
output allowed and RESET
button disabled.
Fully charge
COMPACT JUMP
STARTER
before attempting to
start vehicle.
AMBER
fast
blinking
COMPACT JUMP STARTER
voltage is above 11V (3
bars or more on
COMPACT
JUMP STARTER
), vehicle
battery not detected. No
current output allowed.
NOTE: Clamps are not
connected to vehicle battery
or vehicle battery is below
low limit threshold.
Check for secure battery
cable/clamp connections to
vehicle battery. If AMBER light
continues to fast blink, press
RESET button for vehicle battery
“system check”. NOTE: A vehicle
battery below low limit threshold
may need to be recharged or
replaced.
AMBER
/GREEN
alternating
blinking
Indicates 3 second vehicle
battery “system check” in
progress after pressing
RESET button when
properly connected to a
vehicle battery.
After “system check”, LED will
return with system status
confirmation. Refer to listed LED
Status for further actions.
RED
fast
blinking
COMPACT JUMP STARTER
voltage is above 11V,
cables connected in
reverse polarity or vehicle
battery short detected. No
current output allowed and
RESET button disabled.
Disconnect cables from
COMPACT JUMP STARTER
and
remove clamps from vehicle
battery. Connect clamps to
vehicle battery in correct polarity
(positive-to- positive/negative-
to-negative) and then reconnect
cables to
COMPACT JUMP
STARTER
to reset.
NOTE: Source of
problem must be resolved before
reattempting to start vehicle using
COMPACT JUMP STARTER.
