Tel. +39 049 641 679
|
commerciale@aercomponents.it
|
www.aercomponents.it
37
EN
In this mode the sensors are disabled and the units will run with heat recovery.
The end user can select the desired speed to run the units and this condition remains until a
different command is entered.
Advice for use
Recommended mode when heat recovery is required independently from humidity levels or when
needed to set a fixed speed for all the products.
8.5 NIGHT MODE
To get into this mode, press the button NIGHT (
N
) on remote control, to see the image below
on display.
In this mode all the units will run at the night speed with heat recovery until another command
is entered.
Advise for use
Recommended mode when the external environment is very quiet and even the minimum speed
of the unit is perceived.
8.6 BOOST MODE
To get into this mode, repeatedly press the button TIMER (
B
) on remote control, to see the
image below on display.
By pressing this button in any of the modes all the products will run in extraction at the
maximum speed for 20 minutes, at the end of the cycle they will resume the previous set
mode.
Advise for use
Recommended mode to quickly extract unhealthy air or strong odors without the need to set again
the units afterwards.
