ROBÒ TR800 Instruction Manual
EN
EN
12
CLEANING / REPLACING THE FILTERS
HEPA FILTER AND SPONGE FILTER
1 - Remove the dust container and open the flap
(S)
of the filter compartment.
2 - Extract the HEPA filter
(H)
and the sponge
filter
(F)
.
3 - Clean each filter thoroughly by removing dirt
residues.
PRIMARY FILTER
1 - Open the dust container, empty it and clean
it thoroughly.
2 - Extract the primary filter
(G)
by pulling the
two rings on the side
(W)
.
3 - Clean the filter thoroughly by removing dirt
residues.
F
S
H
G
W
Wear personal protective garments
before emptying the dust container or
cleaning the filters and brushes.
1 - Open the cover
(Q)
using the two levers
(L)
.
2 - Extract the main brush
(R)
from its housing.
3 - Thoroughly clean the bristles of the brush
by removing hair, threads and residues with the
comb
(C)
supplied.
4 - Put the brush back into its housing and close
the cover.
1 - Extract the edge-sweeping brushes by
simultaneously pulling the side bristles with your
hands.
2 - Thoroughly clean the bristles by removing
hair, threads and residues with the comb
(C)
supplied.
CLEANING / REPLACING THE BRUSHES
We recommend using the comb
(C)
supplied with ROBÒ.
3 - Put the brushes back in place by applying
pressure and observing the
L (Left) and R
(Right)
positions indicated on the bristle supports.
Wear personal protective garments
before emptying the dust container or
cleaning the filters and brushes.
Q
R
LEFT
RIGHT
L
WARNING
Check the integrity of the brushes and
replace them it they are broken.
C
C
CLEANING THE EDGE-SWEEPING SIDE BRUSHES
CLEANING THE MAIN BRUSH
Visit the tutorial area dedicated to ROBÒ on www.aertecnica.com
Visit the tutorial area dedicated to ROBÒ on
www.aertecnica.com
WARNING
WARNING
Filters should not be washed
Filters should not be washed
