13
The Laundry Pro 2.0 monitors its operations with a blue LED indicator:
• Unit on
= LED on steadily. (“unit on” means whenever water is flowing through the unit).
• ActivePure Cell Assembly replacement upcoming
(@ approx. 7500 hours) = periodic brief LED flash (visual chirp) when unit is off, but goes to steady on
when water is flowing through the unit.
• ActivePure Cell Assembly replacement required
(@ approx. 9000 hours) = periodic brief LED flash (visual chirp) whether unit is off or on. UV bulb will
NOT
be turned on again until cell is replaced.
• UV bulb failure
= periodic brief LED flash (visual chirp) – same as ActivePure Cell Assembly replacement required above.
• ActivePure Cell Assembly replacement:
When replacing the ActivePure Cell Assembly, there is a switch on the main circuit board which must pressed.
When this happens, the LED will blink 3 times (longer than the brief “chirp” flashes above) and then shut off. This indicates that the ActivePure Cell
Assembly timer has been reset to 0. Pressing the button at any time before the 7500 hour mark
*or*
before a bulb failure has been detected will
NOT
reset the timer.
• Leak Alarm:
LED will flash in conjunction with alarm beeping. If this occurs, please contact Customer Service at 800.572.0502 for assistance.
Some washers monitor the incoming cold water temperature and adjust too cold of water by adding hot water, even if the water temperature is set to cold. If you
have one of these washers, do not install with the “Y” adapter as it may cause the washer to not operate correctly. Consult your washing machine owner’s manual
if needed.
An optional Laundry Pro 2.0 water tap allows you to run water with hydrogen and oxygen based oxidizers for cleaning surfaces, without the cost or chemical
irritants found in most traditional cleaning products.
Status Indicator Light
Circuit Board
TEMPERATURE CONTROLLING WATER VALVES
EXTERNAL WATER TAP (AVAILABLE SEPARATELY)
STATUS INDICATIONS
WARNING
• Electrical Shock Hazard; disconnect power before attempting installation or service
• Electrical Shock Hazard; when working with electrical connections, the appliance and surrounding area should be clean
and dry of any standing water; failure to follow these instructions can result in death, fire, or electrical shock
• Do not operate Laundry Pro 2.0 with the front cover removed or improperly installed; failure to follow these
instructions can result in severe eye damage, death, or electrical shock
