4
ELECTRICAL REQUIREMENTS
100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker. Laundry Pro 2.0 is equipped with an AC to DC power supply.
WATER REQUIREMENTS
A dynamic water pressure greater than 20 psi / 1.37 bar and less than 60 psi / 4.13 bar is required to correctly operate your Laundry Pro 2.0.
LOCATION CONSIDERATIONS
The Laundry Pro 2.0 must never be installed in areas where water may freeze since the unit will always maintain some water in the unit, the water valve,
and hose areas. This can cause damage to internal components. It is also recommended to avoid installation in areas of high humidity, as it can effect the
operation of the unit.
WATER
OUTLET
WATER
INLET
17.3” (43.94 cm)
5.19” (13.48 cm)
3.69” (9.37 cvm)
INSTALLATION REQUIREMENTS
WARNING
Never use an extension cord.
CAUTION
• We strongly recommend that a licensed plumber installs the Laundry Pro 2.0
• Water pressure
MUST
be checked and within stated specs before installation
• If water pressure is greater than 60 psi, Water Pressure Reducer
MUST
be used (sold separately)
• Incoming water pressure must be greater than 20 psi / 1.37 bar; if your household water
pressure is greater than 60 psi / 4.13 bar, you must install an in-line pressure reducer before
installing Laundry Pro 2.0; failure to follow these instructions may result in water leakage,
property damage, personal injury, and may void your warranty. Water pressure of 20 psi /
1.37 bar to 60 psi / 4.13 bar is required to correctly operate your Laundry Pro 2.0; low water
pressure may prevent your unit from operating properly and/or cause a failure in your washing
machine’s water valve
• The washer’s water valve may also not shut off completely; check the documentation supplied with your washing
machine for exact specifications; your washing machine and cold water faucet must be within
4 feet of the right side of the unit to use the inlet hose provided with your Laundry Pro 2.0
• TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A HOSE LEAK, ALWAYS HAVE FAUCETS ACCESSIBLE AND
TURN OFF FAUCETS WHEN WASHER IS NOT IN USE; DO NOT USE WITH A CARBON FILTER
