6
A. If using supplied wall anchors, drill two 3/16” (4.76 mm) diameter holes.
Place two wall anchors into the wall. Install two supplied screws and
tighten until almost all the way in.
B. If mounting to wall studs, drill two 3/32” (2.381 mm) diameter holes
approximately 1” (25.4 mm) deep. Install two supplied screws and tighten
until almost all the way in.
NOTE:
Washing machine and cold water faucet must be
within 4 feet (1.21 m) of the right side of unit.
1. Place the Laundry Pro 2.0 to the wall and mark the appropriate keyholes
with a pencil.
2. Position the keyholes of the Laundry Pro 2.0 onto the screws (not shown).
Finish tightening screws enough to securely mount unit, but still allowing it
to be removed from wall. Remove unit from wall.
NOTE:
The provided hardware kit contains adhesive backed rubber spacers
to be placed on back of unit to provide additional clearance from wall
if needed for hose installation or the use of ActiveClean Port. (Page 12)
17.3” (43.94 cm)
Keyholes
Screws (not shown)
INSTALLATION OF WALL ANCHORS OR SCREWS
