11
Inspection
The WC300 system is shipped with several parts unassembled.
When parts are removed from the packing, they should be
inspected for damage. If any parts are damaged or missing,
contact your supplier.
WARNING:
When handling the media tank
do not turn it upside down or drop on its side.
When the carton is first opened, the softener will be standing
upright.
Figure 7
WARNING:
The brine tank fits tightly over
the valve. When removing the brine tank tip it
forward and rotate slightly to pull off. Take care
not to damage valve cover or control.
To assemble the system, remove the salt tank components (cover,
collar, base and brine tube assembly) from the shipping container.
1. Remove the brine well and parts bags.
2. Lift the brine tank up 2 feet.
3. Turn the brine tank 1/4 turn to the right.
4. Tilt the brine tank toward the label and slowly lift free.
The media tank can now be removed.
To assemble the Brine Tank:
1. Stand the brine tank up and in position. Level as needed. The
tank has two ports that will be connected. One to a drain and
one to the valve.
2. Remove the overflow fitting from the brine tube. Place the
brine tube in position. Align the large hole in the brine well
with the hole in the brine tank. Install the overflow fitting in
this hole to secure well to tank. Lay cover aside for now.
To Assemble the Media Tank:
1. Stand the tank up and in position.
2. If the floor under the media tank is uneven, level as needed.
WARNING:
The media tank contains loose
particles that will shift. If the tank is turned
upside down or laid back quickly, the particles
may enter the valve. If this happens, the valve
may need to be disassembled and cleaned.
Water Line Connections
A bypass valve system should be installed on all water
conditioning systems. A model 1265 bypass is included with this
system. Bypass valves isolate the conditioner from the water
system and allow unconditioned water to be used. Service or
routine maintenance procedures may also require that the system
is bypassed. Service during routine maintenance and servicing
procedures. The illustrations below show the two common bypass
methods.
Normal Operation
In Bypass
BY
PA
SS
BY
PA
SS
B
Y
PA
S
S
B
Y
PA
S
S
Water Conditioner
Water Conditioner
In
Out
In
Out
Figure 8 Model 1265 Bypass (Included)
Water
Conditioner
Water
Conditioner
Water Conditioner
Water Conditioner
Normal Operation
In Bypass
Figure 9 Typical Three Valve Bypass Configuration
(Not provided by manufacturer)
CAUTION!
REMOVE BRINE TANK SLOWLY
4
5
3
2
1
Summary of Contents for Origins WC300
Page 1: ...Operation Manual 00947 1821 EA 03671...
Page 33: ...Manuel d utilisation 00947 1821 EA 03671 A D O U C I S S E U R D E AU WC300...
Page 66: ...66...
Page 67: ...67...
