13
INSTALLING THE PURIFIER PLATE & ACTIVEPURE
®
CELL
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the Aerus Pure & Clean+ without the Filter Assembly and Back Cover properly installed
1.
Slide the ActivePure Cell up and into the
unit. Be sure the back lip of the
ActivePure Cell engages the two slotted
protrusions at the rear of the plate cage,
and that the angle brackets and studs
are correctly aligned.
2. Insert the two thumbscrews and
tighten. Insert the ActivePure®
Cell connector into the plug on the
plate cage.
3. Press the connector firmly until the
two tabs lock into place.
4. Gently insert the Purifier Plate
between the guides
(inside the cage) until it stops.
7. Replace the Back Cover by
inserting the bottom in and
snapping into place..
6. Use the included screwdriver to
screw in the Filter Assembly.
5. Replace the Filter Assembly,
inserting the bottom of the Filter
Assembly first.