+ User Manual
Warning: Some of the components can get very hot, too hot to touch!
If in doubt, use a
moistened finger before probing a package
Never ever leave your system unattended when playing with these kinds of high currents!
The intention is to generate heat, but sometimes the heat will appear at an unexpected
location: An oxidized connector, a connector screw not tightened properly, a bad solder joint.
Any place with some resistance becomes important!
Thermistor Inputs
The analog inputs are used for thermistors that measure the temperature of the temperature
controlled devices, often the heated build platform (HPB or bed) and up to two extruder(s)
NC router specific I/O view
A router will use the stepper signals and limit switches just like a 3D-printer. The power
outputs and analog inputs are free to use for other purposes.
† Be careful and don't use a 'wet' finger as that may cause shorts!
version 1.4.9 (09/04/14)
page 13