G-Model Inverter Heat Pump
9
1) The frame must be fixed with bolts (M10) to concrete foundation or brackets. The concrete foundation
must be solid and secure; the brackets must be strong enough and have antirust treatment.
2) Please don’t place objects that could block the air flow near the inlet or outlet area; there should be no
obstructions within at least 50cm (500mm / 20”) of the back, and sides of the unit (see figure above),
or the efficiency of the heat pump could be reduced or it could even not work at all;
3) In order to function the unit needs to be installed as part of a system with a filtration pump (to be
provided by the user): for the recommended water flow of the circulation pump please refer to the
Technical Specifications of the heat pump.
4) When the machine is running, there will be condensation water from the bottom. Please place the
drainage nozzle (accessory) into the hole and connect a hose to drain the condensation water away.
b.
The inlet and outlet water unions can’t stand the weight of soft pipes. The heat pump must be
connected with hard pipes!
2. Wiring
a. Connect to appropriate power supply, the voltage should comply with the rated voltage of the
products.
b. Earth the machine well.
c. Wiring must be handled by a professional technician according to the circuit diagram.
d. If leakage protector set it (use protector) according to the local regulation of allowed mA.
e.
The layout of power cable and signal cable should be separated from each other.
Summary of Contents for PROTEAM G-Silent G108
