C
OMMUNICATION AND
V
ISUALIZATION
T
ECHNOLOGIES
via Pastrengo, 7/C
– 24068 Seriate (Bergamo)
[ENG]TC-430_Manual_1_116_0_A.doc
Copyright © 2016-2018 Aesys S.p.A.
All rights reserved
37
Figure 36: Route selection
The list of paths defined on the selected
route is shown by pressing the “
Next
” button (Figure 37).
Figure 37: Path selection
At the end, the lis
t of trips defined on the selected path is shown on screen by pressing again the “
Next
”
button (Figure 33).
Alternatively during path selection it is also possible to hold the “
Next
" (thus triggering its second function
“
Drive
”) to just drive the selected path without loading any particular trip. This function can be useful on test
buses for double-checking the correct definition of a path, without the need to drive that path at any given
specific time during the day (as it would happen driving a trip).
7.3.2 Navigation
Once a service is selected (see paragraph 7.3.1) the TC-430
™ screen is turned into navigation mode
During the navigation, the system autonomously command all the signs (external and/or internal) and all
other on-
board equipment depending on the service program defined in Verba 2014™ (see [1] for further
details).
The screen presented while navigating basically reports the list of upcoming stops along the service to be
executed (stops are listed bottom-up, being the next one represented at the bottom of the screen). By
pressing “
Details
” further information about the service being executed can be accessed (Figure 38).
