S
COOPY
+ S - User Manual
41
3.3.
Putting in service
Recommendations for the operation:
The unit is cooled by natural convection; you should not confine it too much for proper
operation.
With the "HD-4G mobile" option, the unit includes two antennas integrated beneath the top
cover. Do not cover the S
COOPY
+ S with metal objects or liquids prone to degrade the
performance of the antennas. For the same reasons, do not confine it in a place where the
reception of the mobile networks is typically bad: underground place, metal furniture, vehicle,
etc. These are example cases where an external antenna can reveal useful.
For operating the codec, the minimum connections to set are (refer to the details in the rear panel
description):
Power source (Batteries and/or external DC)
Audio inputs and outputs (XLR sockets)
Network connections: depending on the network used, Ethernet interface, ISDN line, POTS.
The pin out of the connectors is indicated in chapter 7.1: Characteristics of the audio interfaces.
Before the first use, the equipment must be configured according to the desired operation mode: audio
input/output format, local conditions (network interface parameters…). Then to set up links you must
select the coding type and parameters.
For using the configuration menus, a password may have to be entered. After factory setting or after a
complete configuration erasure, the password is "blank" (no password) and the access is unrestricted.
Afterwards, if needed, a password can be programmed by the user and the restricted access mode can
be activated.
For more details about the codec configuration, see chapter 4 - Detailed operating mode. The setup for
the Ethernet interface is described in 3.4 below (Initial setup of the Ethernet interface).
