S
COOPY
+ S - User Manual
3
1.1.
Install and connect S
COOPY
+ S
Plug on a power source or insert 6 C-size batteries.
Switch on S
COOPY
+ S by holding down
for 3 seconds. (And hold down
for 3 seconds to
switch off)
Connect the necessary audio interfaces (
details: page 20)
Connect S
COOPY
+ S on the transmission network
(details: page 38 and following)
Using the S
COOPY
+ S menus:
key or
key to activate the main menu, use the joystick
to
select a sub-menu or a parameter, enter or validate with the
key.
jumps back up to the
previous menu level, until getting back to the base screen (with level display).
(details: page 47)
1.2.
Audio settings
The microphone(s) to be used must be active ("ON" LED); for instance press
for
microphone 1 if not yet done.
Set the microphone gain to the middle position, white dot up. Make a test with the
microphone. If the level is too strong or too weak on the meters, adjust the gain via the menu
Setup
/
Audio / Inputs / Input x Settings / Gain
, so that you reach an adequate level (
see
details further on page 62)
.
1.3.
Select and set up network to be used: wired networks
Select network:
Setup
menu then
Network
, then select
Change Network
,
. In the
proposed choice, select the desired network (
ISDN
,
Ethernet
,
POTS
). Validate with
.
Select the audio coding: menu
Setup
/
Algorithm
, then
Other
, then
. Browse the available
choice with the arrows, and make a selection with
. Restart the same procedure to change
for another coding setup.
The available choice depends on the transmission network! For more details on coding, see
page15.
1.3.1.
Set up an ISDN link
If needed, select the protocol with
Setup
/
Network
/
ISDN
Parameter
/
Protocol
.
More
details: see page 57.
Enter the remote number to dial, using the keypad, and press the
key.
If more than one B channel is involved due to the coding algorithm used, you must enter a
second number, then
. If the last dialled number is adequate, just confirm by pressing
without typing a number again.
Hang up with the
key to release the connection (you must confirm by pressing
again).