ROBOTAPE 50 ME - LH
6.8. POSITIONING OF SIDE PRESSURE UNITS
Proceed as indicated.
1.
Install rolls
(X)
as shown in the figure according to the width of box
(C)
in relation to the width of taping
unit support
(N)
.
|
Important
If the box is too narrow with respect to taping unit
(N)
, capsize the side press rolls as shown in the figure.
2.
Loosen knobs
(B)
and open side pressure guides
(Y)
to allow introduction of the box.
3.
Place the box below the support of taping unit
(N)
.
4.
Place the side press rolls
(Y)
on the box and tighten by a few mm and make sure both sections
(S)
are
into contact.
5.
Tighten knobs
(B)
once operation is terminated.
|
Important
If the boxes are narrow, you must remove the side press rolls.
31/43
