Remove the Shower Pipe (4).
Place Mounting Face Plate (6) on wall
and use Pencil T-11 (Not included) to
mark center screw holes on wall.
CAUTION:
Before marking holes,
apply duct or masking tape over the
surface area of the tile where the hole
is to be drilled. This helps to prevent
the drill bit from slipping when starting
to drill the hole.
Place tip of the drill bit (1/4") against
the mounting hole mark on the wall or
the masking tape. Drive the drill bit
through each mounting hole mark.
CAUTION:
Do not drill into a water line!
4
2
1
6
1
/
4
”
(
6
mm
)
13
14
15
Insert Screw Anchors (7). And gently
tap anchors into hole with Hammer
T-14 (
Not included
).
Use Philips Screwdriver T-10
(Not included) to gently secure bracket
to wall with 2 screws (8).
Insert Shower Pipe (4) into the bottom
of Shower Arm (3).
6
8
T-10
×
2
7
T-14
3
4
6
9
16
17
18
14
