Maintenance and Repair
48 – 56
Assembly instructions EN
SA-3 I SA-3-FL I SA-6 I SA-6-FL
Edition 01/2021
Rev. 4.5
9.3.3 Lubrication of linear guide
The linear guide is initially lubricated with the special long-life grease on delivery.
The linear guide must be lubricated every 10 million load changes (strokes).
Fig. 16
Telescope spindle axis - grease nipple linear guide
1. Guideways of linear guides
2. Lubrication hole of carriage
Procedure for lubricating the linear guide:
1. Move the axis to the front end position (= max. stroke).
2. Switch off the control and use a lockout device to make sure that the control
cannot be started up again.
3. Remove grease residues or dirt from the guide rail.
4. Lubricate the guideways of the linear guide (Fig. 16, 1) so that an even
lubricating film is applied.
5. Lubricate the carriage with the grease gun (0.2 - 0.4 g).
- Recommended lubricant: Klüber STABURAG S NBU 8 EP.
The lubrication is completed.
After lubrication, perform 2-3 strokes at low speed to distribute the lubricant
optimally.
1
1 2
Summary of Contents for 50113773
Page 54: ...54 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
Page 55: ...Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 55 56 ...
Page 56: ...56 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
