Safety instructions
14 – 56
Assembly instructions EN
SA-3 I SA-3-FL I SA-6 I SA-6-FL
Edition 01/2021
Rev. 4.5
2.8.1 Mechanical hazards
2.8.2 Danger due to electricity
2.8.3 Noise hazards
CAUTION
Risk of injuries by moving parts and unexpected movements!
When operating the telescope spindle axis uncontrolled movements may
occur which can cause personal injury or property damage. There is always
a risk of injury by moving parts during normal operation.
Only qualified personnel may work with or on the telescope spindle axis.
Never reach into the system during normal operation!
WARNING
Danger! Risk of electric shock!
If work on electrical components is required, ensure that the work is carried
out properly, failure to do so will cause serious or fatal injuries.
Work on the machine's electrical equipment may only be performed by
skilled electrician or trained personnel under the supervision of a skilled
electrician in accordance with all relevant electrical regulations.
CAUTION
Noise hazards!
The telescope spindle axis generates 68 dB(A) during full-load operation.
Depending on the add-ons, the environment and the resonance of the
protective device theses values may be exceeded and expose the operator
to a higher noise level.
It is the responsibility of the operating company to ensure that the permitted
noise limit values are not exceeded.
If the permitted noise levels cannot be met it must be ensured that the
operating personnel wears the required hearing protection.
Summary of Contents for 50113773
Page 54: ...54 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
Page 55: ...Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 55 56 ...
Page 56: ...56 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
