Safety instructions
Assembly instructions EN
SA-3 I SA-3-FL I SA-6 I SA-6-FL
Edition 01/2021
Rev. 4.5
9–56
2 Safety instructions
2.1 General
This chapter provides an overview of all important safety aspects to ensure safe
and proper use of the telescope spindle axis and optimal protection of
personnel.
Safe handling and trouble-free operation of the telescope spindle axis requires
knowledge of the basic safety regulations.
Every person carrying out installation, commissioning, maintenance work or
operating the telescope spindle axis must have read and understood the
complete user manual, especially the chapter on safety instructions.
Beyond this, there are rules and regulations regarding accident prevention that
are applicable to the place of installation which must be observed.
Improper use may result in danger to life and limb of the user or third parties or
in damage to the automation system or other material assets.
Failure to follow the directions and safety instructions given in this instructions
manual may result in serious hazards.
2.2 Intended use
The telescope spindle axis series SA-3, SA-3-FL und SA-6, SA-6-FL is designed
for the shock-free linear movement of permanently mounted loads in
non-
explosive environments
and in the ambient and operating conditions defined
for these modules (
technical data sheet in the handling catalogue).
Any use beyond the described purpose is considered to be not in accordance
with the intended use.
The intended use of the module also includes:
observance of all instructions given in this instructions manual,
compliance with the inspection and maintenance work and the
specifications in the data sheets,
using only original spare parts.
2.3 Foreseeable misuse
Any use other than or beyond the intended use described above is considered
a misuse of the telescope spindle axis.
Especially the following use is considered a misuse:
Use in potentially explosive atmospheres
Summary of Contents for 50113773
Page 54: ...54 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
Page 55: ...Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 55 56 ...
Page 56: ...56 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
